Instructions for use and maintenance

We recommend that you always wash your container when you first use it, as there may be residual metal particles or oils resulting from the production process. The use of neutral detergent associated with lukewarm water is sufficient to remove such residues. Avoid using scouring pads, which may damage the steel surface.

It is also advisable to dry the container carefully before use so as to avoid contact of water with the liquid content.

We suggest that you should check the perfect leak-tightness of the container prior to use. For this purpose, fill it up with water and check for possible leaks around the bottom and the tap fitting.


Inside the container you will find a white rubber seal, which must be positioned along the inner circumference of the cap, taking care that it adheres perfectly to the appropriate surface. Then lay the cap and turn it clockwise.

To mount the tap, remove the steel cap fitted to close the hole in the drum by unscrewing it with a coin.

Then screw the tap taking care not to over tighten it. Excessive pressure would actually damage the O-ring, with subsequent leakage from the tap.

For the lever tap: after placing the lever in the desired position, tighten the nut so that the O-ring adheres perfectly to the surface of the drum.

The Oliday and Myfustino lines, of 3 and 5 litres, are already equipped with a tap. However, if you wish to remove it for cleaning or replacement, use a wrench to unscrew the tap and at the same time, from inside the drum, remove the metal ring.

To reassemble, fit the tap into the special hole and lock it from the inside with the metal ring. 

MINOX srl C.da Chianche ZI - Minervino Murge - BT +39 0883 69.43.04 - +39 0883 69.58.74 - Fax +39 0883 69.16.88 info@ilfustino.it